Integrating Tyler Technologies
CAD with PageGate
Follow these steps to use Tyler Technoglogies CAD
Tyler Technologies CAD uses PageGate's GetAscii
module to pass messages to PageGate for delivery.
To configure PageGate to accept the messages from
1) Open the PageGate Admin.
2) Go to Interfaces - GetAscii
3) Set the Polling Directory
to match the output directory of the CAD system.
If you're unsure what to set for this path, please
contact Tyler Tech support.
4) Put a check in Enabled.
5) Click on Apply.
6) Click on Yes.