Integration with Glenayre On-Site Terminals

Configure PageGate to Output to the Glenayre Terminal

1. Open the PageGate Admin.
2. Go to Connectors — Connector X — Settings.

   Any connector can be configured to reference a paging terminal.
3. Set the Serial Port field to match the COM/Serial port the terminal is plugged in to.
4. Check Direct Connect. Click Apply.
5. Right click Carriers, left click Add.
6. Specify the following:

   Name: Glenayre
   Protocol: TAP
   Baud Rate: [Mirror the paging terminal's setting]
   Parity: [Mirror the paging terminal's setting]
   Data Bits: [Mirror the paging terminal's setting]
   Stop Bits: [Mirror the paging terminal's setting]
   Init String: direct
7. Click Apply. Configure recipients to use the Glenayre carrier. Use the pager's cap code or ID in the ID/PIN field.

Configure PageGate to Receive Input from the Glenayre Terminal (GetTAP)

1. Open the PageGate Admin.
2. Go to Interfaces — GetTAP — Settings.
3. Set the Serial Port field to match the COM/Serial port the terminal is plugged in to.
4. Specify Baud Rate, Parity, Data Bits, and Stop Bits to mirror the paging terminal's settings.
5. Set Init String to: direct
6. Check Enabled. Click Apply. When prompted, enable for all existing groups and recipients.