Settings

<< Click to Display Table of Contents >>

Navigation:  PageGate Admin > Using the PageGate Admin > Recipients > Recipient Settings >

Settings

Previous pageReturn to chapter overviewNext page

Settings

Top Previous Next

 

Setting

Function

Full Name

This field is what is displayed in the GUI Client and paging websites.

Recipient

After a recipient has been added, the Recipient field cannot be modified within the settings of the recipient. To modify the Recipient name, please Right Click on the recipient's name in the left hand column and select the Rename option.

Enabled Services

The list of PageGate modules that are enabled and available are listed here. Modules that are not highlighted are not available. Modules not checked are not enabled for this recipient. For example, if the GetAscii module isn't enabled for your recipient, the GetAscii module will not be able to send this recipient any messages.

 

If an Interface is not available and it should be, please make sure that the Interface is enabled both in the Program Settings and in the Interface Settings.

Type

Typically, this field should be set to Normal. There are, however, four options that can be set.

Carrier

This field can only be set to a carrier within the PageGate Admin. This field should be set to the carrier this recipient is tied to. For example, if you are trying to contact a Nextel device, you would need to create a Carrier called Nextel, then set this Recipient's carrier to Nextel.

Failover

If a message is not able to be delivered to this recipient, the message will be automatically redirected to whatever recipient you specify here.

ID/PIN

Enter the ID, PIN, or Email address of the pager, cell phone, wireless device, or email account to be contacted.

Max Chars

The number of characters PageGate will send to this recipient from a message. If this number is greater than the Max Characters setting for the carrier, the message will be broken up into multiple messages (according to the carrier's max character settings), numbered, and sent

Apply

Apply saves all recently made changes to a recipient's settings.