Configuring Authentication Credentials

<< Click to Display Table of Contents >>

Navigation:  PageGate Admin > Using the PageGate Admin > Carriers > Adding a Carrier >

Configuring Authentication Credentials

Previous pageReturn to chapter overviewNext page

Configuring Authentication Credentials

Top Previous Next


Some hosts and connection methods require that you authenticate your traffic. Which is to say, some carriers and connection methods require that you provide a username and password in order to send your messages. To do this:


1)Open the PageGate Admin.


2)Click on the + next to Carriers.


3)Click on the + next to the Carrier that needs the authentication credentials.


4)Click on the Advanced sub-section.


5)Enter any required authentication credentials in the Username and Password fields, if you're using an SMTP based carrier, or just the Password, if you're using a TAP, WCTP or SNPP carrier.