Adding a Recipient to an SMTP Carrier

Top  Previous  Next

Note: You must have a carrier configured to use the SMTP protocol. For steps on how to configure a SMTP carrier, please see the "How to add an SMTP carrier" section.

 

1)Enter a Full Name for the recipient.

RecipientsAddSMTP

 

2)Click inside the Short Name field to have the program automatically fill in the field.

RecipientsAddSMTP2

 

3)From the Carrier dropdown list, select the carrier you have configured to use the SMTP protocol.

 

4)In the ID/PIN field, either enter the email address of this recipient or enter the contact address of their cell phone. For a list carrier contact addresses, please see our support site.

RecipientsAddSMTP3

 

5)Click the Advanced button.

RecipientsAddSMTP4

 

6)Leave the Type as: Normal

 

7)If you wish to leave a note about this recipient, enter it in the Comment1 or Comment 2 fields.

 

8)The Max Chars field in the Recipient Settings determines the maximum number of characters you wish to send to this recipient. If this value is set higher than the Carrier Max Chars value, NotePager Pro will split long messages into multiple messages.

 

9)Set the Priority of the carrier. This can be set to a value from 1 to 100, with 1 representing the highest priority and 100 representing the lowest priority. The default value all carriers and recipients is: 100

 

10) If the device you are sending to can receive both alpha and numeric characters, leave Alpha checked. If the device you are sending to can only receive numeric characters, uncheck Alpha.

 

11) Non-printable characters are things like carriage returns, line feeds, horizontal tabs and the like. If you do not want these characters to appear in messages sent to this recipient, uncheck 'Strip non-printable characters'. If you do not want these characters to appear in messages sent to this recipient, uncheck 'Strip non-printable characters'.

 

12) If 'Strip sender's name' is checked, NotePager pro will not prefix your messages with the sender's name.

 

13) If 'Extract Subject' is checked, NotePager Pro will look within the first 40 characters of your message for a carriage return. If it finds one, everything before the carriage return will be used as the Subject and will not appear in the body of the message. If 'Extract Subject' is unchecked, NotePager Pro will not look for a subject within the message and will instead use the default subject line of 'TEXT MESSAGE'.

 

14) Click on Back.

RecipientsAddSMTP3

 

15) Click on Apply.

RecipientsAddFax4

 

16) Click on OK.