Adding a Recipient to a TONE Carrier

Top  Previous  Next

Note: You must have a carrier configured to use the TONE protocol. For steps on how to configure a TONE carrier, please see the "How to add a TONE carrier" section.

 

1)Enter a Full Name for the recipient.

RecipientsAddTONE

 

2)Click inside the Short Name field to have the program automatically fill in the field.

RecipientsAddTONE2

 

3)From the Carrier dropdown list, select the carrier you have configured to use the TONE protocol.

 

4)Enter the phone number you want the touch tones transmitted to.

RecipientsAddTONE3

 

5)Click the Advanced button.

RecipientsAddTONE4

 

6)Leave the Type as: Normal

 

7)If you wish to leave a note about this recipient, enter it in the Comment1 or Comment 2 fields.

 

8)The Max Chars field in the Recipient Settings determines the maximum number of characters you wish to send to this recipient. If this value is set higher than the Carrier Max Chars value, NotePager Pro will split long messages into multiple messages.

 

9)Set the Priority of the carrier. This can be set to a value from 1 to 100, with 1 representing the highest priority and 100 representing the lowest priority. The default value all carriers and recipients is: 100

 

10) If 'Strip sender's name' is checked, NotePager pro will not prefix your messages with the sender's name.

 

11) Click on Back.

RecipientsAddTONE3

 

12) Click on Apply.

RecipientsAddFax4

 

13) Click on OK.