PageGate can easily be integrated with Honeywell Alarm Panels with the GetTAP module. Honeywell Alarm Panels can output the TAP protocol by modem or by serial line, either of which GetTAP can accept.
Here's how to configure PageGate's GetTAP module to accept traffic from a Honeywell Alarm Panel:
1) Open the PageGate Admin.
2) Go to Interfaces - GetTAP - Settings.
3) Set the "Serial Port" field to match the COM/Serial port of the modem or serial line this system is plugged in to.
4) Specify the following:
Baud Rate: Mirror the paging terminal's setting.
Parity: Mirror the paging terminal's setting.
Data Bits: Mirror the paging terminal's setting.
Stop Bits: Mirror the paging terminal's setting.
Init String: If you're using a modem, set this ATS0=1. If you're using a serial line, set this to the word direct (You'll need to type this in the field)
5) Put a check in Enabled.
6) Click on Apply.
6a) When prompted, you do want to enable this for all existing groups and recipients.
