Static Recipient or Group

Top  Previous  Next

These are the steps on how to configure PageGate to deliver SMS replies from cellular hardware to a static recipient or group. When used in conjunction with two-way messaging in PageGate's GUI Client, this allows you to route replies to a workstation or group of workstations and also allows those workstations to reply back.

 

Note: This only applies to replies to messages sent from the cellular hardware this connector is configured to use.

 

1)In the PageGate Admin, go to Connectors - Connector X - 2-Way.
2way

2)Check 'Enable Replies (GSM-AT and XMPP only).
2way2

 

3)Set 'Reply Carrier' to the carrier using the cellular hardware.
2way3

 

4)Set 'Reply Recipient' to the recipient or group reply messages should route to.
2way4

5)Click Apply.