message for direct connection

[geoff.ph]

sir,

I already connected to the system but tere is and message showing:

6/29/2005 4:59:30 PM ========================================
6/29/2005 4:59:30 PM Start connection to carrier: kfmc2
6/29/2005 4:59:30 PM Connect using TAP protocol
6/29/2005 4:59:30 PM Setting communication parameters
6/29/2005 4:59:30 PM Connected to carrier
6/29/2005 4:59:30 PM Waiting for protocol initialization
6/29/2005 4:59:30 PM Sent:<CR>
6/29/2005 4:59:33 PM Received:<LF><CR> invalid entry<CR><LF>Pager number:
6/29/2005 4:59:33 PM Sent:<CR>
6/29/2005 4:59:38 PM Received:<LF><CR> invalid entry<CR><LF>Pager number:
6/29/2005 4:59:38 PM Sent:<CR>
6/29/2005 4:59:43 PM Received:<LF><CR> invalid entry<CR><LF>Pager number:
6/29/2005 4:59:43 PM Sent:<CR>
6/29/2005 4:59:49 PM Received:<LF><CR> invalid entry<CR><LF>Pager number:

But if iam using the modem it sends the message.

thank you for the support
Richard

[Tech Support]

On most paging terminals/encoders the ports can be set to two modes of operations: TAP or text entry mode. When the port is set to TAP, it will respond with an "ID=" each time a connection is requested. When the port is set for text entry, it will provide a more human readable prompt, like the "Pager number:" prompt you are seeing in the log.

You need to set the port on the terminal/encoder back to TAP mode. This is sometimes a software setting in the terminal/encoder, and it is sometimes an actual jumper on the interface card (depending on the equipment you are using). Sometimes simply resetting the port will do the trick.