PageGate GetAscii – autoscroll” log

[csteiger01]

Page Version is 5.0

Seeing numerous log messages


“Message rejected”
“Incomplete data file”
“Program Halted”
“Module restarted”
Paging process has been creating ‘phantom’ Bad Files, appearing in
E:\Pager and Fax\bad\
as ZERO-length files, with file names that exactly replicate the file names of the ‘good’ paging files in
E:\Pager and Fax\good\
except for the fact that the empty phantom file names appear to have been named/created exactly two-hundred-thousandths of a second LATER than the good files.

These 0 K ‘bad’ files are also showing up in the PageGate PG Monitor, where we have over 1,263 Bad pages showing under “GetAscii.”

As far as I know or can tell, the extraneous empty files are not causing a problem with the actual operation of the paging through CAD. People ARE getting paged. However, the empty files are building up a lot of error messages both in the PG Monitor and in the E:\Pager and Fax\bad\ folder

I would like to find out what is causing this if possible

[OzCom]

Could be any number of things - please send your direct contact info off list and I'll call you tomorrow

_________________
Aaron D. Osgood
Streamline Communications, LLC
* Authorized Notepage, Inc. Development Partner and Re-seller
TEL: 207-518-8455
AOsgood@streamline-solutions.net
Creators of AutoPage Spillman CAD interface for PageGate

[OzCom]

UPDATE (for those following this thread):

Determined customer running PageGate v3 - process started to upgrade to current version 5

_________________
Aaron D. Osgood
Streamline Communications, LLC
* Authorized Notepage, Inc. Development Partner and Re-seller
TEL: 207-518-8455
AOsgood@streamline-solutions.net
Creators of AutoPage Spillman CAD interface for PageGate