GetTap

Description - This object contains settings and status information for the GetTap interface.

Functions (accessible by right-clicking on the object)

Start - this will start the GetTap interface (if the PageGate application is currently running).

Stop - this will stop the GetTap interface (if the PageGate application is currently running).

Settings

Enabled - check this box to enable the GetTap interface.

Serial Port - choose the serial port (COM port) you want the GetTap interface to use to accept incoming TAP message sessions.

Baud Rate - set the baud rate to match the speed that the incoming data will be sent at. The default speed is typically 1200.

Parity - set the parity to match the parity that the incoming data will be sent using. The default parity is typically Even.

Data Bits - set the data bits to match the number of data bits that the incoming data will be sent with. The default data bits is usually 7.

Stop Bits - set the stop bits to match the number of stop bits that the incoming data will be sent with. The default stop bits is usually 1

Init String - the init string is a set of commands sent to the modem to configure it for incoming calls and to turn on or turn of features of the modem. For example, most systems using the TAP protocol communicate at 1200 baud with not error correction or data compression.

Status - this displays the current state of the GetTap Interface

Log - If logging is enabled, this log shows the activities of the GetTap interface, including all messages accepted and rejected by it.

Refresh - displays the most current entries in the log

Print - sends a copy of the log file to a printer

Purge - deletes the log's entire contents

Clipboard - copies the log's contents to the Windows clipboard, allowing it to be pasted into another application