TigerConnect supports receiving messages by WCTP.
Step 1: Configure TigerConnect as a delivery method
1)Run PG Admin. 
2)Right click Carriers, select Add 
3)Specify the following and click Apply:
Carrier: TigerConnect
Protocol: WCTP
Host: wctp.tigertext.me/wctp
Port: 443
Max Chars: 160
|

|
4)Go to Carriers - TigerConnect - Advanced 5)Specify the following:
Priority: 1
Username: Enter the TigerConnect UserID.
Password: Enter the TigerConnect password.
|

|
6)Click Apply
Step 2: Create Recipients tied to the TigerConnect method of delivery
1) Right click Recipients, select Add. 
2)Specify the following:
Full Name: The name of the recipient
Recipient: This field will automatically populate but can be edited and may ONLY contain alphanumeric characters, underscores and dashes.
Type: Normal
Carrier: TigerConnect
Failover: See Failover Scenarios
ID/PIN: 10 digit cell phone number
Correct
|
Incorrect
|
7818290500
|
1781829500
|
Max Chars: Specify the number of characters you want the ability to send to this recipient. If this value is higher than the carrier's "Max Chars" value, PageGate will break up long messages in to multiple blocks.
|

|
3)Click Apply.
|