Rover supports receiving messages by WCTP.
Special Notes:
•Port 443 will need to be open for WCTP. Step 1: Configure Rover as a delivery method
1)Run PG Admin. 
2)Right click Carriers, select Add 
3)Specify the following and click Apply:
Carrier: Rover
Protocol: WCTP
Host: websvc.spotteddogtech.com
Port: 443
Max Chars: 6000
|

|
4)Go to Carriers - Rover - Advanced 5)Specify the following:
Priority: 1
Username: Contact Rover to obtain this information.
Password: Contact Rover to obtain this information.
|

|
6)Click Apply Step 2: Create Recipients tied to the Rover method of delivery
1) Right click Recipients, select Add. 
2)Specify the following:
Full Name: Describe the agency being messaged
Recipient: This field is auto-populated and may need to be edited. When integrating with a CAD system, this field will need to reflect CAD's name.
For example, if CAD is going to dispatch 'Palentine Fire District 2' by calling on the name pfd2, that is the value you would use in this field.
Type: Normal
Carrier: Rover
Failover: See Failover Scenarios
ID/PIN: Enter the Rover ID
Max Chars: 6000
|

|
3)Click Apply.
|