Configuring EMG |
Top Previous Next |
To begin the process of registering on Sprint's EMG, you'll want to contact your Sprint representative or go to https://emg.sprint.com
EMG supports receiving messages by SNPP and SMTP. With all both, we can configure a failover system where the program will use the best method of delivery (SNPP) first and if that fails, it makes a last ditch attempt to send it out via email (SMTP).
Special Notes: •Port 444 will need to be open for SNPP. •To configure the SMTP failover, you will need to know your SMTP server address, port to connect on and required authentication credentials.
Step 1: Configure Sprint-PRIMARY as a delivery method 1)Run PG Admin.
2)Right click Carriers, select Add
3)Specify the following:
4)Click Apply. Step 2: Configure Sprint-FINAL as a delivery method 1)Right click Carriers, select Add
2)Specify the following:
3)Go to Carriers - Sprint-FINAL - Advanced 4)Specify the following:
5)Click Apply 6)Go to Carriers - Sprint-FINAL - Template 7)Specify the following in the 'Settings' section:
8)Click Apply.
Step 3: Configure the failover system 1)Go to Carriers - Sprint-PRIMARY - Advanced 2)Click the dropdown arrow next to 'Failover' and select: Sprint-FINAL 3)Click Apply
Step 4: Create Recipients tied to the Sprint-PRIMARY method of delivery 1) Right click Recipients, select Add. 2)Specify the following:
3)Click Apply. |