Overview

<< Click to Display Table of Contents >>

Navigation:  PageGate Admin > Using the PageGate Admin > Interfaces > GetTap >

Overview

Previous pageReturn to chapter overviewNext page

Overview

Top Previous Next

The GetTap Interface is used to accept incoming messages via the TAP protocol. The GetTap interface accepts these message in one of two ways. It can accept the messages over a serial connection or it can accept incoming messages through a modem connected to the PageGate PC.

 

The TAP protocol is the most widely used text messaging protocol for serial and dialup connections. The GetTap Interface enables PageGate to accept in text messages from many sources and dispatch the messages back out to a different source.

 

Also, PageGate can act as a messaging gateway for TAP clients (such as NotePager32 and NotePager Pro), simplifying setup, logging, and providing a single connection for sending messages to a wide variety of carriers.