Success and Failure Notification Templates

Top Previous Next

This type of Template is completely unlike the other Templates. These templates trigger a specific behavior within the program and are not contained within the Administrative GUI.

This feature will allow you to configure PageGate to send notifications when a message succeeds or when a message fails.

When a message is successfully delivered, PageGate looks for a file named successnotifylist.txt in the PageGate program folder. This file can contain a list of email addresses that will receive notification that the message was successful. You can use the special value %Sender% on one of the lines to have the sender of the message in the list.

In addition you will need to create a file named success.mtp and place it in the PageGate program directory. This file is used as a template for what is sent in the success notification message. It uses the same variables as the Macros.

The same process happens for a failed message, but it uses a failurenotifylist.txt and a failure.mtp file instead.

Create a successnotifylist.txt file in the PageGate folder with a single line containing %Sender%

Do the same for a failurenotifylist.txt file.

The success.mtp file should look like this:

Subject: Successful Message To %Recipient%

Message Info:

Recv: %RequestedDate% %RequestedTime%

Sent: %Date% %Time%

To: %Recipient%

From: %Sender%

Msg: %Message%

The failure.mtp file should look like this:

Subject: Failed Message To %Recipient%

Message Info:

Recv: %RequestedDate% %RequestedTime%

Fail: %Date% %Time%

To: %Recipient%

From: %Sender%

Msg: %Message%