<< Click to Display Table of Contents >>

Navigation:  Installation > Installation Options > Additional PG Monitor >


Previous pageReturn to chapter overviewNext page


Top Previous Next


There are a few things that should be verified and setup before the installation of PG Monitor:


1)Be sure your hardware meets the minimum specs for PG Monitor


2)Be sure the computer that PG Monitor is to be installed on is configured for your network. The monitoring program uses TCP/IP. Although TCP/IP is not required for running PageGate, it is recommended that it be installed on the PageGate server so the monitoring program can be used.


3)Be sure that you have sufficient permissions (if applicable) to install new programs on the chosen computer.


4)In some cases, you will be asked to restart your computer after the installation of PG Monitor. If so, this must be done before PG Monitor is run. Be sure that you install PG Monitor at a time when this can be done.


5)ALWAYS be sure to have a complete backup of your system before installing ANY new software! The installation of PG Monitor is NOT and exception to this rule.