To configure the Ad-Hoc GetMail function to accept messages addressed to the device you wish to contact:
1.
|
Create a new recipient and set its Type to Ad-Hoc.
|
2.
|
Make sure that GetMail is checked under the Enabled Services section of the recipient.
|
3.
|
Select the carrier that messages addressed to your paging recipients should be sent to via the Ad-Hoc function.
|
4.
|
Once the Recipient has been configured, put a check in "Enable Ad-Hoc Mail".
|
5.
|
Click on the Add button.
|
6.
|
Enter the Starting ID/PIN.
|
7.
|
Enter the Ending ID/PIN.
|
8.
|
Select an Ad-Hoc Recipient from the drop-down menu.
|
|
|
To use this method with email, simply address an email message to the PageGate Server's Local Domain with an ID/PIN number (within the range set in steps 6 and 7 above) as the part of the email address before the @ (i.e. 1234567@mypagegateserver.com).
|