Top Previous Next |
1)Right click Carriers. 2)Select Add. 3)Select the TONE protocol. 4)Enter a name in the Carrier field. 5)If your modem requires a special initialization string to send DTMF, enter it in the Init String field. 6)Set the Max Chars field to the maximum number of digits you want to transmit in a single dial-in session. 7)The Wait String field determines how long the program should pause before transmitting the touch tones in the message. Your modem uses the Hayes AT command set, which means a comma represents a two second pause and an @ represents a 3 second pause.
8)Click Apply. 9) Go to Connectors - Connector X - Settings. Note: Any connector can use a modem but a connector can only be tied to one modem at a time. Multiple connectors cannot reference the same modem. 10) Set the Serial Port field to match the COM port of the modem. 11) Click Apply.
Click here for a list of Settings Variables that can be used with TONE Carriers |