NotePage, Inc. Forum Index

Notepager32 sends but says its bad.

 
Post new topic   Reply to topic    NotePage, Inc. Forum Index -> NotePager Pro Support
View previous topic :: View next topic  
Author Message
Quest



Joined: 22 Jul 2005
Posts: 3
PostPosted: Fri Jul 22, 2005 7:29 am    Post subject: Notepager32 sends but says its bad. Reply with quote
Notepager32 successfully sends an SMS but never indicates that it was sent.
eg. Sent 0 Bad 1. Is it me or Telstra that is at fault?
22/07/2005 9:21:56 PM ====================================
22/07/2005 9:21:56 PM Start connection to carrier: carrier1
22/07/2005 9:21:56 PM Connect using TAP protocol
22/07/2005 9:21:56 PM Setting communication parameters
22/07/2005 9:21:56 PM Sent:AT<CR><LF>
22/07/2005 9:21:57 PM Attempting to reset modem
22/07/2005 9:21:59 PM Sent:AT<CR>
22/07/2005 9:21:59 PM Received:<CR><LF>OK<CR><LF>
22/07/2005 9:22:00 PM modem reset
22/07/2005 9:22:00 PM Attempting to send carrier init string
22/07/2005 9:22:00 PM Sent:AT&FQ0V1X4&D2N0+MS=V22,0<CR>
22/07/2005 9:22:01 PM Received:<CR><LF>OK<CR><LF>
22/07/2005 9:22:02 PM Carrier init string sent
22/07/2005 9:22:02 PM Dialing carrier
22/07/2005 9:22:02 PM Sent:ATDT018018767<CR>
22/07/2005 9:22:10 PM Waiting for connection
22/07/2005 9:22:23 PM Received:<CR><LF>CONNECT 1200 V42<CR><LF>
22/07/2005 9:22:23 PM Connected to carrier
22/07/2005 9:22:23 PM Waiting for protocol initialization
22/07/2005 9:22:28 PM Sent:<CR>
22/07/2005 9:22:29 PM Received:ID=<CR>
22/07/2005 9:22:29 PM TAP protocol detected
22/07/2005 9:22:29 PM Sent:<ESC>PG1mnmail<CR>
22/07/2005 9:22:31 PM Received:<CR><ACK><CR><ESC>[p<CR>
22/07/2005 9:22:31 PM Received:<CR><ACK><CR><ESC>[p<CR>
22/07/2005 9:22:31 PM Automatic TAP mode accepted
22/07/2005 9:22:31 PM ------------------------------------------------
22/07/2005 9:22:31 PM Working on message to: XXX from:
22/07/2005 9:22:31 PM Formatting message
22/07/2005 9:22:31 PM Message contained in single block
22/07/2005 9:22:31 PM Sending block
22/07/2005 9:22:32 PM Sent:<STX>xxxxxxxxxx<CR>test message<CR><ETX>6>6<CR>
22/07/2005 9:22:48 PM Received:<CR><LF>NO CARRIER<CR><LF>
22/07/2005 9:22:48 PM No response from carrier. Disconnecting
22/07/2005 9:22:48 PM Message retry limit reached
22/07/2005 9:22:48 PM FAILED To:McA Msg:test message
22/07/2005 9:22:48 PM Carrier retry limit reached. Marking pending messages as bad
22/07/2005 9:22:48 PM Sent:<EOT><CR>
22/07/2005 9:22:48 PM Attempting to hang up modem
22/07/2005 9:22:51 PM Sent:AT<CR>
22/07/2005 9:22:51 PM Received:<CR><LF>OK<CR><LF>
22/07/2005 9:22:51 PM modem hung up
cheers
Quest
Back to top
View user's profile
Poncho67



Joined: 21 Jun 2005
Posts: 12
PostPosted: Fri Jul 22, 2005 10:22 am    Post subject: Reply with quote
Looks like your modem did not receive the terminal's acknowledgement response<ACK> after NP32 sent the message block.

Try using this Init Sting:
AT&FQ0V1X4&D2N0+MS=V22

If it continues, try dropping the Baud Rate to 300 and reset the Carrier Init String to "(auto)".
Back to top
View user's profile
Quest



Joined: 22 Jul 2005
Posts: 3
PostPosted: Sat Jul 23, 2005 9:11 am    Post subject: Reply with quote
Tried both suggestions.
Messages still sent successfully but NotePager32 still marks them as Bad.
BTW its a Lucent Win Modem and I'm using Telstra in Australia.
Back to top
View user's profile
Poncho67



Joined: 21 Jun 2005
Posts: 12
PostPosted: Mon Jul 25, 2005 5:03 am    Post subject: Reply with quote
Increase the Baud up to 2400 or 9600 and use "(auto)" for Init String.
Back to top
View user's profile
Quest



Joined: 22 Jul 2005
Posts: 3
PostPosted: Mon Jul 25, 2005 7:44 am    Post subject: Reply with quote
Lifted the baud rate and selected Auto.
Messages still sent successfully but NP32 thinks they are bad.

25/07/2005 10:33:26 PM Dialer Started
25/07/2005 10:33:45 PM Dialer Stopped
25/07/2005 10:33:46 PM Dialer Started
25/07/2005 10:34:06 PM ====================================
25/07/2005 10:34:06 PM Start connection to carrier
25/07/2005 10:34:06 PM Connect using TAP protocol
25/07/2005 10:34:06 PM Setting communication parameters
25/07/2005 10:34:06 PM Attempting to reset modem
25/07/2005 10:34:09 PM modem reset
25/07/2005 10:34:09 PM Auto detecting modem init string
25/07/2005 10:34:14 PM Attempting to send init string
25/07/2005 10:34:16 PM Init string sent
25/07/2005 10:34:16 PM Dialing carrier
25/07/2005 10:34:24 PM Waiting for connection
25/07/2005 10:34:39 PM Connected to carrier
25/07/2005 10:34:39 PM Waiting for protocol initialization
25/07/2005 10:34:44 PM TAP protocol detected
25/07/2005 10:34:47 PM Automatic TAP mode accepted
25/07/2005 10:34:47 PM ------------------------------------------------
25/07/2005 10:34:47 PM Working on message to: XXX from: From XXXX
25/07/2005 10:34:47 PM Formatting message
25/07/2005 10:34:47 PM Message contained in single block
25/07/2005 10:34:47 PM Sending block
25/07/2005 10:34:49 PM Disconnect requested by carrier. Disconnecting

Maybe the problem starts here.

25/07/2005 10:34:49 PM Message retry limit reached
25/07/2005 10:34:49 PM FAILED To:XXX Frm:From XXXX Msg:message6
25/07/2005 10:34:49 PM Carrier retry limit reached. Marking pending messages as bad
25/07/2005 10:34:50 PM Attempting to hang up modem
25/07/2005 10:34:54 PM modem hung up

Thanks for your suggestions.
Back to top
View user's profile
Display posts from previous:   
Post new topic   Reply to topic    NotePage, Inc. Forum Index -> NotePager Pro Support All times are GMT - 5 Hours
Page 1 of 1

 
Jump to:  
You cannot post new topics in this forum
You cannot reply to topics in this forum
You cannot edit your posts in this forum
You cannot delete your posts in this forum
You cannot vote in polls in this forum


Powered by phpBB © 2001, 2002 phpBB Group
Theme created by Vjacheslav Trushkin