| View previous topic :: View next topic |
| Author |
Message |
Tech2YK
Joined: 04 Aug 2009
Posts: 12
Location: York PA
|
 Posted: Tue Aug 04, 2009 12:40 pm Post subject: Pin out for the Serial Direct conncection |
 |
|
Does anyone have the pinout for using the direct serial connection? I am connecting to the Zetron 2700 I have the Zetron side of the house I need to make a cable to go from pagegate server to the Zetron Terminal. Any help would be much appreciated. I have tried searching for it.
Thank you
"The new guy on the Block"
|
|
| Back to top |
|
Tech Support
Joined: 25 Aug 2003
Posts: 4387
|
| Posted: Tue Aug 04, 2009 12:43 pm Post subject: |
|
|
| You should be able to use a standard DB9 cable to go from the PC to the terminal... unless you're referring to the CAP Code PIN in the terminal? I wasn't sure if you were referring to the cable pins or the CAP Code pins. |
|
| Back to top |
|
Tech2YK
Joined: 04 Aug 2009
Posts: 12
Location: York PA
|
| Posted: Tue Aug 04, 2009 12:58 pm Post subject: |
|
|
| Zetron accepts a 25 pin cable and uses pins 2, 3 and 6 I need to figure out which ones on the db9 cable are used in this fashion.
|
|
| Back to top |
|
Tech Support
Joined: 25 Aug 2003
Posts: 4387
|
| Posted: Tue Aug 04, 2009 1:01 pm Post subject: |
|
|
| Oh. I'm not sure, to tell you the truth. I'd check with Zetron on that one. |
|
| Back to top |
|
Tech2YK
Joined: 04 Aug 2009
Posts: 12
Location: York PA
|
| Posted: Tue Aug 04, 2009 1:06 pm Post subject: |
|
|
Below is the configuration for Zetron. I just need to know how pagegate utilizes the 9 pin serial connection so I can go from 9 pin (pagegate) to the 25 pins for Zetron. Basically a 9 pin to 25 pin cable is what I need to make. Any thoughts? Thank you for your help
Purpose Pins
Chassis Ground 1
Transmit Data (TD) 2
Receive Data (RD) 3
Request to Send (RTS) 4
Clear to Send (CTS) 5
Data Set Ready (DSR) 6
Signal Ground 7
Carrier Detect (CD) 8
Data Terminal Ready (DTR) 20
Ring Indicator (RI) 22
|
|
| Back to top |
|
OzCom
Joined: 22 Oct 2003
Posts: 1122
Location: US
|
| Posted: Tue Aug 04, 2009 1:37 pm Post subject: |
|
|
Try a standard RS-232 serial cable with a DB9 to DB 25 adaptor._________________ Aaron D. Osgood
Streamline Communications, LLC
* Authorized Notepage, Inc. Development Partner and Re-seller
TEL: 207-518-8455
AOsgood@streamline-solutions.net
Creators of AutoPage Spillman CAD interface for PageGate |
|
| Back to top |
|
Tech2YK
Joined: 04 Aug 2009
Posts: 12
Location: York PA
|
| Posted: Tue Aug 04, 2009 5:11 pm Post subject: |
|
|
| So far I have the adaptor configurastion hooked up. We will be firing the server up tomorrow for the first time. Wish me luck
|
|
| Back to top |
|
|
