Setting up the lookup table

[asg070]

What is the procedure and/or syntax used for setting up the lookup table in Page Gate specifically for recipients. I'm trying to filter out pages brought in from get serial and send them to specific recipients. Thanks.

[Tech Support]

In the PageGate Admin, go to the Interfaces - GetSerial - Settings - Recipient section.

Put a check mark in the Use Lookup Table box and left click on Edit Table.

When the lookup table comes up, you'll notice there are two sections: Data In and Data Out.

The Data In is the string the program is going to replace. The Data Out is the string the program should replace it with.

So, if you're receiving TECH as a recipient in the incoming transmission and you actually want that message to go to a recipient named BOBO, you would put TECH as the Data In and BOBO as the Data Out.

[asg070]

I'm familiar with the procedure but I was unsure of the syntax. There is NO user information contained within the "Data In" stream coming in on the get serial port. Can I still get a message that has the word "Temperature" in it and send it out to whomever I wish by using the procedure you described? Simply type in a key word on the in side and the name of a recipient in the out side correct?

[Tech Support]

Right, you could set it up to do that as well.

For example, if you wanted all messages with the string "ALARM 001" to go to your Technicians group, you would put ALARM 001 as the Data In and Technicians as the Data Out.