How does this work....

[Jay]

This is confusing... I really dont know where to start, can anyone direct me in right direction as to how do i go about setting up pagegate.

Thanks

Jay

[Tech Support]

Here is the basic order of setting up PageGate:

1. Install PageGate
2. Run PG Admin
3. Accept defaults on initial setup screen (a new database will be created)
4. Run PG Admin again
a. Setup Dialer1 (found under Connectors)
b. Setup a Carrier
c. Setup a Recipient
5. Start the PageGate Monitor
6. Start the PageGate Server
7. Send a test page from PG Admin (right-click on a recipient and choose 'Send Message')
8. Watch the PG Monitor to see what happens
9. If successful, continue. If not, check your Dialer, Carrier, and Recipient settings.
10. In PG Admin, configure the Interface you want to use
11. Start the newly configured interface (right-click, and choose 'Start')
12 Send a test from the newly enabled Interface.

I hope this is helpfull. Typically, the more specific you are with your questions in the forum, the better answers you will get.

[rob]

When I started page gate, It says "Setup information not Found"

This is a registered version of Pagegate, so I am not sure what that means or where the information is that it is looking for.

[Tech Support]

If possible, could you answer the questions below so that we can troubleshoot further?

Which Operating System (Win95/98/ME, 2000, XP, 2003) are you using?
What are the exact steps required to duplicate the error message?
Are you selecting a shortcut or trying to run an executable directly?
What other applications are running when this happens