Method 2

Top Previous Next

To set up the GetMail module to accept email with the ID/PIN numbers on the subject line of incoming email:

1.	Create a new recipient and set its Type to 'Ad-Hoc'.

2.	Make sure that GetMail is checked under the Enabled Services section of the recipient.

3.	Select the carrier that messages addressed to this recipient should be sent to.

To use this new ad-hoc recipient account via email, send email addressed to the ad-hoc recipient (recipientname@localdomain.com)and in the subject line enter one or more ID/PIN numbers (separated by spaces or commas).

PageGate will then use the carrier associated with this ad-hoc recipient to deliver a copy of the email message to each ID/PIN number on the subject line of the email.